Low Type Wire Mesh Partition

Basic Panels Up to 12 Feet High
Specifications – Standard Duty 

Many other combinations of wire size and spacing are available. Square or rectangular patterns of woven wire are also obtainable as well as various channel sizes. Panels made in any width up to recommended maximum of 5’0″. Single panel height recommended to 12’0″. All corners mortise and tenon.

The Following Types are Made of 11/2″ Diamond Mesh and 10 GA. (.135″) Wire with Channel Framing as Shown.

 

Vertical Frame 1″ x 1/2″ x 1/8″
Horizontal Frame 1″ x 1/2″ x 1/8″
Hinge Doors 1″ x 1/2″ x 1/8″
Slide Doors 1″ x 1/2″ x 1/8 All doors are banded, on all four sides with 1/8″ thick bar.
Horizontal Stiffeners 1″ x 3/8″ x 11 ga CH, riveted position
Locks Mortise cylinder type, keyed one side, recessed turn knob other side.
Top Capping Bar 1 1/2″ x 1/2″ x 1/8″ CH

Installation: Wire partitions are designed that they may be erected by inexperienced labor. Shop drawings are sent with all jobs so that your erector will understand how parts are assembled. Field bracing of partitions may also be desired, depending on job conditions and individual preferences. Bracing materials will be furnished only when the type and quantity are specified. (Bracing is usually furnished by the erector). All bolts and screws for assembling are included. (However, bolts and screws for anchoring work to buildings are not included unless specified).

Ordering: When ordering it is best to send a rough sketch, so that we may fabricate with the correct arrangement of doors and windows etc., Be sure to state height as well as the type of floor and walls to which the partitions anchor. If there are pipes or other obstructions around which the partitions must fit, show dimensions and location. Indicate the direction of opening for doors and key side.